The IGET Bar Plus S3 Device is the rechargeable half of IGET’s modular pod system, and it is the part you buy once. Instead of sealing a battery, a coil and a flavour into one disposable shell, this body keeps the 950mAh cell, the USB Type-C port and the battery readout, while the pod carries the e-liquid and mesh coil. When a pod empties, you click in another one. The IGET Bar Plus S3 Device stays in your hand, charged and ready.

That single design decision changes how the kit behaves day to day. You are not locked into one flavour for a week, you are not guessing how much charge is left, and you are not paying for a fresh battery every time a coil fades.

What arrives in the box

The device listing is body-only, and that is deliberate. Nothing in the box is meant to be thrown away after a few days.

• One IGET Bar Plus S3 Device body in your chosen finish
• USB Type-C charging cable
• Quick-start card and authenticity code

No pod is included. If this is your first purchase, add at least one S3 pod to the same order, because the body cannot vape on its own.

IGET Bar Plus S3 Device specifications

Those numbers matter more than they look. A sealed disposable of the same capacity is finished once it drains, while the IGET Bar Plus S3 Device resets the figure every time you plug in. That makes 950mAh roughly double the usable life of a typical throwaway, even before you count the pods the body saves you from replacing.

Five finishes, one chassis

The IGET Bar Plus S3 Device is sold in five colourways, and the finish is the only difference between them. Mystic Gunmetal and Tidal Gunmetal sit at the sober end, Carbon Gray is the neutral workhorse, and Light Purple and Rose Pink are the two that stand out on a desk. Each one uses the same stainless-steel frame and the same internals, so pick on looks rather than expecting a performance difference.

How the battery screen works

The small display is the feature most people notice first. Tap or draw and it shows an approximate charge level, so you know whether you have a full evening ahead or need ten minutes on the cable. On a sealed disposable the same information arrives as a sudden drop in vapour, usually at the worst possible moment.

Treat the readout as a guide, not a stopwatch. It reports the cell voltage, so it will sit high for a while and then fall faster near the end of the charge. Topping up when it reaches around 20 to 30 percent keeps the draw consistent and is gentler on the cell than running it flat every time.

Charging the right way

The IGET Bar Plus S3 Device charges through a Type-C port, but it is not a fast-charge product. Use a standard 5V/1A adapter; a 45W laptop brick will not fill it any faster and can add unnecessary heat. From empty, a full charge takes roughly 60 to 90 minutes.

Charge on a hard, non-flammable surface, unplug once the indicator settles, and avoid charging overnight on a bed or sofa where heat cannot escape. Never leave the device in a hot car; heat is the fastest way to shorten the life of any lithium cell.

Which pods fit, and how they differ

The body accepts two generations of pod. The current S3 pod is rated to about 10,000 puffs and uses a 1.0 ohm mesh coil. The older BAR PLUS pod is rated to roughly 6,000 puffs. Both click into the same slot, and the device manages power the same way for each, so there is no switch to flip.

Pairing the IGET Bar Plus S3 Device with the right pod matters more than most buyers expect. Heavy users tend to prefer the larger S3 pod because it means fewer changes. Vapers who rotate flavours often prefer the smaller pod, because it is cheaper to switch and easier to finish before the flavour fades. Both routes work with the same IGET Bar Plus S3 Device.

Setting it up in under a minute

Charge the body, remove the silicone cap from the pod, and push the pod in until it seats. Wait a minute before the first draw so the mesh can saturate, then simply inhale. There is no button, no menu and no airflow ring to adjust.

Three habits keep the system tasting clean. Store it upright so the pod wicks properly, take two to three second draws instead of long pulls, and wipe the contacts with a dry tissue whenever the draw starts to feel tight.

Who should buy the body on its own

This listing suits three people: someone replacing a lost or damaged body, someone who already owns S3 pods and needs the other half, and someone buying a second body so one can charge while the other is in use. It does not suit a first-time buyer with no pods, and it is not a rebuildable device, so there is nothing to wire or fill.

Care, storage and safety

Keep spare pods capped and upright, away from direct sun. Do not store the device in a glovebox or on a windowsill. Clean the mouthpiece with a dry tissue rather than water, and keep the whole kit out of reach of children and pets. Nicotine products are intended for adults aged 21 and over, and the device should only be used with compatible IGET pods.

For guidance on vaping and health in Australia, see the Department of Health resources. To compare flavours first, browse our IGET Bar Plus S3 pod range.

Frequently asked questions

Does the IGET Bar Plus S3 Device include a pod?

No. The IGET Bar Plus S3 Device is body-only, so add at least one pod to your order.

Can I use BAR PLUS 6000 pods on this body?

Yes. The body accepts both the S3 10,000-puff pod and the earlier BAR PLUS pod.

How long does the battery last between charges?

Expect roughly a day of moderate use. Heavy users may charge once in the evening.

Does the IGET Bar Plus S3 Device have a button?

No. The device is draw-activated; the screen and the charging port are the only interfaces.

Which finish should I choose?

Pick on taste. Carbon Gray and the two Gunmetal finishes are the most understated; Light Purple and Rose Pink are the boldest.

Ready to build your setup? Add the IGET Bar Plus S3 Device to the cart, then choose two or three pods so you can rotate flavours without changing hardware.