The IGET Bar Plus is a popular and reliable disposable vape, but like any electronic device, it can occasionally run into problems. Before you consider it a lost cause, try these practical, step-by-step solutions to get your device working again.
Before You Begin: Safety First
Do not attempt to open, modify, or “hack” the device. Disposable vapes are sealed units not meant for repair. Tampering can damage the internal battery, causing leaks or safety hazards.
Use the correct charger. Only use a low-power USB-A port (like on a computer, gaming console, or old phone charger block) or a certified 5V/1A power adapter. Avoid fast chargers or high-power USB-C ports.
Check if it’s truly empty. The IGET Bar Plus is designed for approximately 3500 puffs. If you’ve used it extensively, it may simply be finished.
Step-by-Step Troubleshooting Guide
Problem 1: Device Won’t Hit / No Vapour Production
This is the most common issue. Follow these steps in order.
Check the Battery Indicator: Take a puff and observe the small LED light at the base. No light at all means the battery is completely dead. A flashing light typically indicates a low battery or a connection issue.
Recharge the Device: Even if advertised as “disposable,” the IGET Bar Plus has a USB-C port for recharging.
Gently clean the USB-C port of any dust or pocket lint using a dry toothpick.
Plug it into a low-power USB-A port using a standard USB-C cable.
Charge for 20-30 minutes. Do not leave it charging overnight.
Unplug and try taking a puff.
Prime the Coil & Clear Blockages (The “Flick” Method): Sometimes, e-liquid can be too thick or a small bubble can block the wick.
Firmly flick the device (mouthpiece down) into a tissue or sink several times, as if you’re flicking ink from a pen. This uses centrifugal force to move liquid through the coil.
Cover the bottom airflow holes with your fingers and take 2-3 sharp, short, dry puffs (without activating the auto-draw, if possible). This can help pull liquid into the coil.
Let it sit for 5-10 minutes and try again.
Check for Airflow Blockage: Ensure the airflow holes at the bottom of the device are not blocked by your fingers, a table, or debris.
Problem 2: Device is Gurgling, Spitting, or Leaking
This is usually caused by excess e-liquid in the centre chimney.
Dislodge the Liquid: Immediately hold the device with the mouthpiece facing down over a tissue.
Swing it firmly (mouthpiece down) to force excess liquid out onto the tissue. Repeat until the gurgling stops.
Wipe the mouthpiece clean with a tissue before using it again.
Problem 3: Burnt or Muted Flavour
This often signals the end of the device’s life or a dry coil.
Stop Immediately: Continuing to puff on a burnt coil will not fix it and will taste terrible.
Let It Rest: If the device is new or barely used, set it down on its side (not upright or upside down) for 30-60 minutes. This allows the e-liquid to re-saturate the cotton wick fully.
Try a Gentle Primer Puff: After resting, take a very gentle, short puff. If the burnt taste persists, the coil is likely damaged and cannot be fixed.
Problem 4: Device Won’t Charge
Try a Different Cable and Port: Your cable or USB port might be faulty. Switch to a different, known-working cable and a low-power USB port.
Clean the Port: Use compressed air or a dry toothpick to carefully remove any compacted lint from the USB-C port.
Check for Visible Damage: Look at the USB-C port for any bent or misaligned pins. If damaged, the device cannot be safely charged.
When to Stop Troubleshooting: The “Unfixable” Problems
If you’ve tried all the above and your IGET Bar Plus still doesn’t work, it’s likely one of the following issues:
The battery has reached the end of its lifecycle.
The e-liquid tank is completely empty.
There is an internal hardware fault (a disconnected wire or a dead battery cell).
The Best Solution for a Faulty Device: Contact Your Retailer
If your IGET Bar Plus is genuine, recently purchased, and failed prematurely, your best course of action is to contact the retailer for support.
As an authorised stockist of genuine IGET products, iGetBaroz stands behind the quality of every device they sell. If you purchased from them:
Have your order details ready.
Describe the issue clearly (e.g., “won’t hit after a full charge,” “burnt taste from the first puff”).
Reputable retailers like iGetBaroz often have warranty processes or customer service solutions for authentic products that are dead on arrival or fail significantly before their expected lifespan.
Prevention for Next Time: Always purchase from authorised and trusted retailers like iGetBaroz to guarantee you receive a genuine, high-quality IGET Bar Plus with reliable performance from the first puff to the last.